Laths Sentence Examples | Use Laths in a sentence

1.as compared with the ni cr b si c clad, the matrix produced a microstructure of crb Laths distributed in the ni solid solution and a small amount of ni+ m 23 c 6 eutectic between ni dendrites after the tic particles were added.

2.the result shows that the mechanism is composed of three steps: ① subdivision of austenite grains into homogeneous and tiny martensite Laths with plenty of dislocations with c atoms absorbed during quenching and tempering before severe rolling;

3.a mechanism involving natural selection of practically movable slip system and continuously turning of Laths due to inhibition of lath boundaries to motion of dislocation was proposed.

4.the deformed band and transformed band are made up of very fine martensite Laths, its hardness is much higher than that of the as-quenched specimen.

5.comparatively high content of h 2o was favorable for the faster growth of quartz than albite. finally, the quartz phenocrysts which contained albite Laths might form snowball texture.

6.the paper discusses the twin theory and other theses on the habit plane of the lath martensite, the direction relationship and the relative oriented relationship between Laths.

7.woodworking maschines; machines for production of core stock from Laths; nomenclature

8.this firm is well connected with the manufacturers of Laths and thus is able to supply various kinds of Laths.

9.it is pointed out that the structures of high toughness weld seams contain over 90% needle-like ferrite, few or no proeutectic ferrite and flank plates or Laths ferrite.

10.tem study on relative orientation between adjacent martensite Laths

11.we will order some Laths for furnishing the basement.

12.tremolite Laths and serpentine minerals are present in places.

13.hot deformation induced t ( q) twin and α 2 ( q) Laths in α tial based two phase alloy

14.hematite phenocrysts, up to 1-2 mm in size, can be seen to occur as euhedral Laths disseminated in massive ores.

15.the Laths of acicular ferrite nucleated at inclusions grow radially, and the depletion of alloying elements such as mn and ti may increase the driving force for ferrite transformation, which will lead to form acicular ferrite preferentially in the region.

16.thinning and damage of martensite Laths and increase of dislocation density in Laths during severe rolling;

17.the normalized microstructure of the modified high cr ferritic heat-resistant steels is composed of martensitic Laths with high density dislocation, and a small quantity of δ-ferrite.

18.building Laths cut in half and sharpened on one end make satisfactory stakes.

19.the orientation between a and two martensitic Laths may follow different equivalent k-s relationship.

20.analysis of rejected torsion of reinforced thin walled beam with Laths